Exposure to environmental heat outdoor · Effects of heat n.e.c.
At a glance
Federal OSHA recorded a severe workplace injury
at Tonage Inc., 2150 Hempstead Turnpike, ELMONT, NEW YORK 11003
on — Effects of heat n.e.c., affecting the BODY SYSTEMS .
Watch Tonage Inc. — freeGet an email when a new federal OSHA severe-injury report for Tonage Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was installing rebar on a grandstand deck when he began experiencing lightheadedness and was hospitalized for heat-related illness and dehydration.
An employee was prefabricating rebar pile cages on horses when his leg was struck by a rolling pile cage, fracturing his knee and requiring hospitalization.
On October 7, 2025, employee was installing mulch with a landscape crew. At around 2:15 PM, the employee took a break and started to feel cramping/pain. The employee was taken to the hospital with rhabdomyolysis due to heat exhaustion.
A temporary employee was on top of a cane wagon, throwing cane down to the ground (i.e., planting). He reached the end of the field row and started to feel ill. He experienced cramping and headaches due to heat exhaustion.
An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.
An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.