Ecobat Resources New York, LLC

On 10/16/2023, at 4:06 PM, an employee was performing a repair on a mold conveyor. A hydraulic jack shifted causing the load to drop approximately 2-3 inches onto cribbing underneath that was being used to support the load. The employee's right hand was pinched between the impact wrench he was using and the floor. The employee's hand was lacerated.

An employee was working on the grill when they began to feel ill. The employee was hospitalized to treat heat-related illness. The air conditioning was not working at the location.

An employee had been working in a fabrication area conducting preassembly of solar modules. The employee was hospitalized for heat-related illness, rhabdomyolysis, and renal failure.

An employee was working in the baking chambers of the tire retread center for 5.5-6 hours in approximately 100-degree heat. He developed severe pain and full body cramping. The employee was hospitalized with severe dehydration and heat exhaustion resulting in back pain and a kidney injury.

An employee was working at an individual selection machine when he began to suffer heat stress, resulting in hospitalization.

On August 8, 2025, an employee developed muscle cramps and dizziness. Later, while working on a plant floor, he developed full-body cramps. He was hospitalized, suffering from head exhaustion.

An employee was monitoring a conveyor at the operator station. A piece of metal was fed to a conveyor system and it struck another piece of metal, causing a piece of titanium (1-inch-long and 1/2-inch-wide) to break off and strike the employee in their upper chest below the clavicle. The employee was hospitalized and the embedded piece of metal was surgically removed.

An employee was working by the slag side of a reverb in the furnace department. They returned home after the end of their shift and began feeling muscle cramps, resulting in hospitalization due to dehydration.

On May 14, 2025, an employee was sitting cross-legged and removing a pneumatic rail car vibrator from its bracket to empty the next pocket in the rail car. When the employee went to set the vibrator down, he placed it on a hammer that was sitting in front of him and the vibrator teetered to the side, catching his little finger. The employee sustained an amputated fingertip at the first knuckle.

An employee was opening a railcar compartment using a wrench when the tool broke and the employee slipped and fell to the same level. The employee sustained a fractured lower right leg.

On December 28, 2024, at 10:23 AM, the injured employee was spotting for the operator of a shear crane while conducting tree trimming/removal operations. The injured employee was standing about 4 feet from the ground on top of scrap steel trusses. After the shear crane cut the tree, it began dragging a large branch which struck the injured employee and knocked him down onto the scrap pile. He sustained four broken ribs on the left side and a left lung contusion. The employee was hospitalized.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.