Southern Style Manufacturing

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was using a motorized chain hoist to lift a pump weighing 600 to 700 pounds onto a working table. The hoist, which weighed approximately 100 pounds, fell from an overhead crane onto the employee s fingers, resulting in a finger amputation.

An employee was changing a strainer when 180- to 190-degree sugar solution splashed from an open valve onto the employee, who suffered burns.

While explaining to a co-worker how to install a new gate on the palletizer machine, an employee's left thumb tip was amputated by the machine's piston.

The injured employee and a co-worker were moving a tank car loaded with molasses from the loading station to the designated side of the facility using a wheel loader to pull the rail car. The employees reached an incline and applied the handbrake. While they repositioned the wheel loader to push the rail car the remaining distance to their destination, the rail car started to move backward. The injured employee climbed onto the rear platform of the car to tighten the brake, but the rail car collided with the loader bucket and the employee suffered fractures to their right femur and tibia.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.