Milwaukee Valve Company, LLC

An employee was activating the sprinkler system at a sports complex following recent maintenance to repair leaky pumps. When the system was activated, a section of newly installed 3-inch schedule 80 PVC pipe struck the employee, who lost consciousness. The employee suffered a broken jaw and a concussion.

An employee was cutting metal with a torch. A piece of metal struck the employee's left foot, causing multiple fractures to metatarsal(s). The employee was hospitalized.

An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.

An employee was installing a rear suspension airbag beneath a hydro-excavation truck when the airbag slipped off the truck's frame and struck him in the face. The employee sustained multiple facial fractures and an intraparenchymal hemorrhage and was hospitalized.

An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.

An employee was performing a machine set-up and had installed one set of holding jaws. His right index finger became caught in an air vise while re-clamping a part. The employee sustained a partial amputation above the fingernail.

Two employees were re-packing a butterfly valve. The valve was being held by a crane. An employee added air to the valve to close it. The valve moved and the other employee reached to steady it. His thumb was caught in the valve and the thumb tip was amputated.

An employee was preparing to install a production tree/master valve. The employee grabbed the bull plug and shook the production tree into place. The well blew out on the casing side. The pressure caused the production tree to fall over onto the employee, resulting in a fractured right leg.

An employee was manually moving a 30-pound valve. When he sat the valve down, it crushed his left index fingertip just above the nail and amputated it.

An employee was stepping over a protective barrier when his foot was caught by the barrier, causing him to fall to the concrete ground. His left arm was fractured.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.