105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Ingalls Shipbuilding, Inc

Other fall to lower level 6 to 30 feet · Fractures

Federal OSHA recorded a severe workplace injury at Ingalls Shipbuilding, Inc, 1000 Jerry St. Pe Highway, PASCAGOULA, MISSISSIPPI 39567 on — Fractures , affecting the Trunk and hip joint(s).

An employee was descending a ladder carrying a bag of trash. He fell, landed on the ground about 10 feet below, and suffered fractures to his right hip and pelvis.

Hospitalized Trunk and hip joint(s) Portable ladders and stairs unspecified

Ingalls Shipbuilding, Inc

An employee was preparing to bend a flat bar in a brake press. When the machine was jogged, the stock rotated up and crushed his left middle fingertip against the outer frame of the die. The fingertip was amputated.

Ingalls Shipbuilding, Inc.

An employee removed a welded lug that was attached to a ramp he was standing on and he fell. The employee sustained a closed head injury, right rib fractures, a right scapula fracture, a right pelvis fracture, and a lung infiltrate injury.

Ingalls Shipbuilding, Inc.

An employee was ascending in an aerial lift. He was pinned between the lift's control panel and the hull of a ship, suffering injuries to the liver and spleen.

Ingalls Shipbuilding Inc.

An employee was carrying a piece of steel plate (25 pounds, 2' x 4' x 1/8") when it slipped and lacerated his arm. The employee was hospitalized with a 10-inch laceration to his right forearm including injuries to tendons and an artery and required surgery.

Ingalls Shipbuilding, Inc.

An employee was working on scaffolding when he stepped on an unsecured section of piping and fell. The employee's left arm struck part of the scaffold structure, resulting in a fracture to the upper arm.

View Ingalls Shipbuilding, Inc's full OSHA safety record →

Cashless Tolling Constructors

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

Cornell & Company, Inc.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

Anderson Columbia Co., Inc.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

Freeman Expositions, LLC

An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.

Faler Feed Store, Inc.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

Ingalls Shipbuilding

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

Electric Boat Corporation

An employee was struck by a plasma cutter and suffered a broken left tibia and fibula. The employee was hospitalized.

Ingalls Shipbuilding, Inc

An employee was preparing to bend a flat bar in a brake press. When the machine was jogged, the stock rotated up and crushed his left middle fingertip against the outer frame of the die. The fingertip was amputated.

All Star Metals, LLC

An employee was cutting metal with a torch. A piece of metal struck the employee's left foot, causing multiple fractures to metatarsal(s). The employee was hospitalized.

Coastal Mechanical Systems, LLC

An employee was working with a drill and a metal cable. The drill caught the cable and caused an amputation to the employee's left ring finger.

Howard Industries Inc.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

Hobby Lobby Stores, Inc.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

Owl's Head Alloys West Point

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

Ingalls Shipbuilding

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

Heavy Equipment Movers and Installation, LLC

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.