Pedestrian struck by vehicle backing up in nonroadway area · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Don Martin Corporation, Upland Rd, NORWOOD, MASSACHUSETTS 02062
on — Fractures , affecting the Multiple lower extremities locations n.e.c..
Final narrative
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
Hospitalized Multiple lower extremities locations n.e.c. Skid-steer loaders, mini loaders
An employee was diagnosing the cause of a rear light malfunction on a forklift when the reverse gear engaged. The forklift moved backward and contacted the employee causing a metatarsal fracture in their left foot and injury to their lower right leg.
An employee was collecting shopping carts in the parking lot when he was struck by a customer's truck as it was backing out of a parking spot. The truck pinned the employee's left leg against the cart mule they were using. The employee was hospitalized with a fractured leg and required surgery.
An employee took a picture of the seal and license plate on a delivery truck after loading. The truck then reversed back to the dock and pinned the injured employee against the dock. The employee sustained an abdominal fracture.
An employee was between a milling machine and an 18-wheeler belly dump when the 18-wheeler backed up and ran over his feet and legs. The employee was caught between the front of the milling machine and the truck. The employee sustained fractures to their hip, leg, and feet.
An employee was holding a form board on a section of pavement. A skid steer backed into the employee's ankle, breaking it. The employee was hospitalized.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was between a milling machine and an 18-wheeler belly dump when the 18-wheeler backed up and ran over his feet and legs. The employee was caught between the front of the milling machine and the truck. The employee sustained fractures to their hip, leg, and feet.
An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.
Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.
An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.