Day & Zimmermann Lone Star LLC

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a pad printer. The employee's finger was caught in the printer and they suffered a fingertip amputation. The part of the printer that caught the employee's finger was unguarded at the time.

Employees were hooking up a new reel of pipe to be processed into shorter lengths. This process involved routing a winch cable through a haul-off and attaching it to the pipe using a clamp. One employee held the winch cable while another pressed the feed-out button to loosen the cable. The cable tightened and pulled the hand of the employee holding it into a pulley. The employee's right index and middle fingertips were amputated at the first knuckle.

At about 2:15 p.m. on February 10, 2025, employees were unloading pallets of propellant into a storage warehouse. The pallets were double stacked, and a top-loaded pallet had shifted in transit. Two employees were manually moving the pallet when the fiber packs shifted, causing one employee's left index finger to be pinched between the fiber pack and the pallet. The employee suffered a partial amputation to the fingertip.

An employee was walking on the sidewalk near the administrative building when he slipped on ice and fell to the concrete ground. The employee suffered a left hip fracture and was hospitalized.

A CNC operator was trying to replace a bearing in the hydraulically operated steadying fixture in a CNC machine. The fixture retracted, amputating the end of his right thumb.

An employee was changing an insert in the tool head of a CNC machine. The employee had stepped up approximately 28 inches onto the door track of the machine. When the employee went to step back down to the floor, they lost balance and fell backward onto a rack of metal parts. The employee sustained a compression fracture to the spine.

An employee was pushing a cart loaded with 15 rounds of ammunition shells into an oven. The funnel broke off, causing an explosive to go off. The employee sustained burns on the right side of his head.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.