Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: LTV STEEL COMPANY INC

Accident-driven inspection · Safety discipline

On , OSHA opened an accident-driven safety inspection of LTV STEEL COMPANY INC in 999 PINE AVENUE, WARREN, OH 44483 (NAICS 000000). OSHA activity number 1664028.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch LTV Steel Company INC — free Get an email when a new federal OSHA severe-injury report for LTV Steel Company INC is published. One employer, no account, unsubscribe in one click.
Site address
999 PINE AVENUE
City
WARREN
State
OH
ZIP
44483
Inspection type
Accident-driven (A)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
A
Opened
Closing conference
Case closed
Data loaded
NAICS code
000000
SIC code (legacy)
3312
Employees
3000
Ownership type
A

1 citation on file for this inspection.

5(a)(1)

Serious 1 instance 30 exposed
Issued
Oct 10, 1985
Abate by
Oct 13, 1985
Penalty
Initial $720 · Current $720
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not furnish employment and a place of employment which were
free from recognized hazards that were causing or likely to cause death
or serious physical harm to employees in that:
On or before May 24, 1985, employees utilizing the South walkway,
Coke conveyor #4, were exposed to the hazard of falling from an
elevated level of approximately sixty (60) feet in height due to
inadequate securement of a walkway pad. The second walkway pad from
the top (west end) consisted of a reinforced concrete slab 2' 8-3/8
x 2'8 3/4" x 2"; the pad was situated atop support members (angle
iron/I Beams)  and located adjacent to an open area underneath the
conveyor.  No vertical member was in place between the pad and the
opening to prevent the pad from shifting northward due to vibrations,
etc., slipping off of the support members and falling to the ground.
Methods of abatement include but are not limited to:
1) Installing of a vertical member (clip) to prevent the likelihood
of the pad from moving northward.
2) Installation of a concrete pad, or alternate cover over the opening
under the conveyor designed so as to restrain movement of the walkway
pad northward.

View LTV Steel Company INC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 1664028.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.