OSHA Inspection: DOUG MCCOY CONSTRUCTION, INC.

Issued

2013-03-27 00:00:00

Penalty

Initial $1600.00 · Current $800.00 Reduced

General-duty citation text

29 CFR 1926.453(b)(2)(v):     A body belt was not worn and/or a lanyard was not attached to the boom or basket when working from an aerial lift: Note:  As of January 1, 1998, subpart M of this part (1926.502(d)) provides that body belts are not acceptable as part of a personal fall arrest system.  The use of a body belt in a tethering system or in a restraint system is acceptable and is regulated    (a) South side of structure-Toyota Dealership; On or about February 4, 2013, and at times prior thereto, an employee without a personal fall arrest system was observed elevated in an aerial lift approximately 20 feet.    Note : Abatement certification IS NOT required for this item.

Issued

2013-03-27 00:00:00

Abate by

2013-04-02 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.453(b)(2)(iv):     Employee(s) working in an aerial lift were not standing firmly on the floor of the basket:    (a)  South side of structure - Toyota Dealership; On or about February 4, 2013 and at times prior thereto, an employee was observed in an aerial lift utilizing the railing to exit the basket to gain access the roof structure without any fall protection.     Note: Abatement certification IS required for this item.

Issued

2013-03-27 00:00:00

Abate by

2013-04-02 00:00:00

Penalty

Initial $1600.00 · Current $800.00 Reduced

General-duty citation text

29 CFR 1926.501(b)(10):     Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system.      (a)  Toyota Dealership, Twin Falls, ID:  On or about February 4, 2013, and at times prior thereto, employees were performing roof tear-off activities without a fall protection system in place.    Note: Abatement certification IS required for this item.

Issued

2013-03-27 00:00:00

Abate by

2013-04-22 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.503(a)(1):     The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:    (a)  Toyota Dealership, Twin Falls, ID:  On or about February 4, 2013, the employer did not develop and/or provide a training program to enable each employee to recognize the hazards of falling and what procedures should be followed to minimize these potential hazards.    Note: Abatement certification IS required for this item.

Issued

2013-03-27 00:00:00

Abate by

2013-05-13 00:00:00

Penalty

Initial $1600.00 · Current $800.00 Reduced

General-duty citation text

29 CFR 1926.850(a):  Evidence in writing was not available that an engineering survey performed by a competent person had been performed prior to permitting employee(s) to start demolition operations:    (a)  Toyota Dealership:  On or about February 4, 2013, and at times prior thereto, prior to start of demolition operations an engineering survey was not made available in writing.    Note: Abatement certification IS required for this item

Issued

2013-03-27 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.100(a):     Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets:    (a)  South side of structure-Toyota Dealership:  On or about February 4, 2013, and at times prior thereto, employees exposed to overhead hazards while involved in a roof tear off project were not protected with protective helmets.    Note: Abatement certification IS NOT required for this item.