Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: TRES PALACIOS MARINE, L.P.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of TRES PALACIOS MARINE, L.P. in 111 FRIERY ROAD, PALACIOS, TX 77465 (NAICS 336611). OSHA activity number 339364234.

Watch Tres Palacios Marine, L.P. — free Get an email when a new federal OSHA severe-injury report for Tres Palacios Marine, L.P. is published. One employer, no account, unsubscribe in one click.
Site address
111 FRIERY ROAD
City
PALACIOS
State
TX
ZIP
77465
Mailing
111 FRIERY ROAD, PALACIOS, TX 77465
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
336611
Employees
70
Ownership type
A

7 citations on file for this inspection.

1915.81 C03

Other-than-serious 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3500.00 · Current $3500.00
29 CFR 1915.81(c)(3):   When working in wet conditions, the employer did not maintain drainage and provide false floors, platforms, mats, or other dry standing places:    At this workplace, employees welded barge sections in place while standing on saturated ground and near muddy stagnate water which had mixed in welding slag and chemicals.
Recent events (2)
  • — I (O) $3500
  • — Z (S) $3500

1910.134 E01

Serious Gravity 1 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $2100.00 · Current $1155.00 Reduced
29 CFR 1910.134(e)(1): The employer did not provide a medical evaluation to determine the employee ability to use a respirator, before the employee was fit tested or required to use the respirator in the workplace:     At this workplace employees welded barge sections in place and were required to use half face respirators without a medical evaluation.
Recent events (2)
  • — I (S) $1155
  • — Z (S) $2100

1910.134 F02

Serious Gravity 5 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.134(f)(2): Employee(s) using tight-fitting facepiece respirators were not fit tested prior to initial use of the respirator:   At this workplace employees welded barge sections in place and were required to use half face respirators without being fit tested before initial usage.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1915.56 B02

Other-than-serious 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3500.00 · Current $7000.00
29 CFR 1915.56(b)(2): Welding cable was not free from repair or splices for a minimum distance of 10 feet from the cable end to which the electrode holder was connected:    At the workplace employees welded barge sections in place and utilized welding cables with repairs less than ten feet from the user.
Recent events (2)
  • — I (O) $7000
  • — Z (S) $3500

1915.56 B04

Other-than-serious 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1915.56(b)(4): When welding cable became worn to the extent of exposing bare conductors, the portion exposed was not protected by means of rubber tape, friction tape, or other equivalent insulation.     At this workplace employees welded barge sections in place and utilized welding cables with exposed copper conductor which were not repaired or replaced.
Recent events (2)
  • — I (O) $0
  • — Z (S) $0

1910.303 B01

Other-than-serious 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3500.00 · Current $0.00 Reduced
29 CFR 1910.303(b)(1): Electrical equipment was not free from recognized hazards that were likely to cause death or serious physical harm to employees, in that the employer did not ensure the safety of the equipment pursuant to the considerations in sections (i) through (viii) of 29 CR 1910.303(b)(1):       At this workplace employees welded barge sections in place and utilized welding equipment without inspecting for electrical hazards before use on devices such as but not limited to:             a. Welding cable with burnt spot through the cable insulation located at the bottom deck assembly area.           b. Welding machine Lincoln Model TM 500/500 Ideal arc with a hole in the vent housing located at the bottom deck assembly area.
Recent events (2)
  • — I (O) $0
  • — Z (S) $3500

1910.305 A02 I

Other-than-serious 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3500.00 · Current $3500.00
29 CFR 1910.305(a)(2)(i): Temporary electrical power and lighting installation(s) 600 volts, nominal, or less were used in prohibited manners:    At this workplace, employees worked at the fabrication shop, a lifting magnet was recharged by routing an electrical extension cord to a power receptacle and had been in place and used in this manner for more than ninety days.
Recent events (2)
  • — I (O) $3500
  • — Z (S) $3500

View TRES PALACIOS MARINE, L.P.'s full OSHA safety record →

RNWBL

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339364234.