OSHA Inspection: CHICAGONE DEVELOPERS, INC.

Issued

2014-07-17 00:00:00

Abate by

2014-09-03 00:00:00

Penalty

Initial $400.00 · Current $400.00

General-duty citation text

29 CFR 1903.19(c)(1): Within 10 calendar days after the abatement date, the employer must certify to OSHA (the Agency) that each cited violation has been abated, except as provided in paragraph (c)(2) of this section.  The employer did not provide the required abatement certification for the following cited violations:  a) 29 CFR 1910.147(c)(1) - Citation 1 Item 1 b) 29 CFR 1910.217(c)(2)(i)(a) - Citation 1 Item 2

Issued

2013-12-03 00:00:00

Abate by

2014-03-04 00:00:00

Penalty

Initial $2000.00 · Current $2000.00

General-duty citation text

29 CFR 1910.147(c)(1): Energy control program. The employer shall establish a program consisting of energy control procedures, employee training and periodic inspections to ensure that before any employee performs any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative.    Production area - On or about September 16, 2013, a written energy control program (lockout/tagout) consisting of specific procedures and training was not available for employees exposed to the hazards of moving parts when performing service (cleaning and/or unjamming) on the L&J part revolution punch press, (serial #257888) and other operating equipment.

Issued

2013-12-03 00:00:00

Abate by

2014-03-04 00:00:00

Penalty

Initial $2000.00 · Current $2000.00

General-duty citation text

29 CFR 1910.217(c)(2)(i)(a): Each point of operation guard shall prevent entry of hands or fingers into the point of operation by reaching through, over, under or around the guard;    Production area - On or about September 16, 2013 the L&J part revolution press serial #25788A was not completely guarded, thereby exposing employees to the hazards of reaching into the die opening.