OSHA Inspection: SIGMAMOTOR INC.

Issued

2017-03-14 00:00:00

Abate by

2017-04-26 00:00:00

Penalty

Initial $2897.00 · Current $2173.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(1): The employer did not establish an energy control program consisting of energy control procedures, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energizing, start up or release of stored energy could occur and cause injury, the machine or equipment would be isolated and rendered inoperable.  a) On or about 02/23/17, throughout machine shop, employer failed to establish an energy control program that consists of specific energy control procedures, authorized employee training and periodic inspections to ensure employees perform energy control procedures before servicing or doing maintenance such as but not limited to, changing the blade on the horizontal band saw or changing the coolant on the CNC machines.    ABATEMENT CERTIFICATION REQUIRED

Issued

2017-03-14 00:00:00

Abate by

2017-04-05 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.147(c)(6)(i): The employer did not conduct a periodic inspection of the energy control procedure at least annually to ensure that the procedure and the requirement of this standard were being followed:  a) On or about 02/23/17, in the Machine shop, employer did not conduct periodic inspections of the Lockout/Tagout procedures for machines such as, but not limited to: the Horizontal Band saw or CNC Equipment.  ABATEMENT CERTIFICATION REQUIRED