Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: SIMON ROOFING AND SHEET METAL CORPORATION

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of SIMON ROOFING AND SHEET METAL CORPORATION in BUILDING 1605 FORT EUSTIS, FORT EUSTIS, VA 23604 (NAICS 238160). OSHA activity number 342267671.

Watch Simon Roofing AND Sheet Metal Corporation — free Get an email when a new federal OSHA severe-injury report for Simon Roofing AND Sheet Metal Corporation is published. One employer, no account, unsubscribe in one click.
Site address
BUILDING 1605 FORT EUSTIS
City
FORT EUSTIS
State
VA
ZIP
23604
Mailing
70 KARAGO AVE., YOUNGSTOWN, OH 44512
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
15
Ownership type
A

2 citations on file for this inspection.

1926.404 B01 I

Deleted Serious Gravity 5 1 instance 7 exposed
Issued
Abate by
Penalty
Initial $7243.00 · Current $0.00 Reduced
29 CFR 1926.404(b)(1)(i): Employer did not use either ground fault circuit interrupters as specified in paragraph (b)(1)(ii) of this section, or an assured equipment grounding conductor program as specified in paragraph (b)(1)(iii) of this section to protect employees on construction sites.  a)    Fort Eustis Building 1605: On or about 04/14/2017, the ground fault circuit interrupter three way pigtail used to supply temporary power to a battery charger and reciprocating saw was not used properly in that the ground fault circuit interrupter was not plugged directly into the permanent power of the building when used with a yellow 100 ft. extension cord.      Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
  • — I (S) $0
  • — Z (S) $7243

1926.405 A02 II I

Other-than-serious 1 instance 7 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.405(a)(2)(ii)(I): Flexible cords and cables were not protected from damage, sharp corners and projections, or pinch points.     a)    Fort Eustis Building 1605: On or about 04/14/2017, the yellow100 ft. extension cord used to provide temporary power to a reciprocating saw and battery charger, had been routed between a metal door and metal frame thus exposing the cord to a pinch point.    Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
  • — I (O) $0
  • — Z (S) $0

View SIMON ROOFING AND SHEET METAL CORPORATION's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342267671.