Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: LOS ALTOS FENCE & SUPPLY, INC.

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of LOS ALTOS FENCE & SUPPLY, INC. in 3501 MIDPOINT DRIVE, LANCASTER, TX 75134 (NAICS 423990). OSHA activity number 343178356.

Watch LOS Altos Fence & Supply, INC. — free Get an email when a new federal OSHA severe-injury report for LOS Altos Fence & Supply, INC. is published. One employer, no account, unsubscribe in one click.
Site address
3501 MIDPOINT DRIVE
City
LANCASTER
State
TX
ZIP
75134
Mailing
2207 WIMBLEDON DRIVE, ARLINGTON, TX 76017
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
423990
Employees
8
Ownership type
A

2 citations on file for this inspection.

1926.21 B02

Other-than-serious 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $3326.00 · Current $0.00 Reduced
29 CFR 1926.21(b)(2): The employer shall instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to illness or injury.    29 CFR 1926.21(b)(2): The employer shall instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to illness or injury.    29 CFR 1926.21(b)(2): The employer did not instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to illness or injury:    a) This violation occurred on or about and times prior to May 15, 2018, where at least one (1) employee was not trained to recognize unsafe conditions to control or eliminate hazards.
Recent events (2)
  • — I (O) $0
  • — Z (S) $3326

1926.302 E03

Other-than-serious 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $3326.00 · Current $0.00 Reduced
29 CFR 1926.302(e)(3): Any tool found not in proper working order, or that develops a defect during use, were not immediately removed from service and not used until properly repaired:    a)  This violation occurred on or about May 15, 2018; where at least one (1) employee was operating a Little Beaver Gas Powered Auger (serial/model numbers not legible).
Recent events (2)
  • — I (O) $0
  • — Z (S) $3326

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343178356.