1,224,460Inspections Most recent open 2026-07-13 Last loaded 2026-07-16
Safety Incidents OSHA Severe Injury Reports · 2015–2025

OSHA Inspection: SERVICE KING MANUFACTURING, INC.

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of SERVICE KING MANUFACTURING, INC. in 700 N. OLD STROUD RD., STROUD, OK 74079 (NAICS 333132). OSHA activity number 345167027.

Watch Service King Manufacturing, INC. — free Get an email when a new federal OSHA severe-injury report for Service King Manufacturing, INC. is published. One employer, no account, unsubscribe in one click.
Site address
700 N. OLD STROUD RD.
City
STROUD
State
OK
ZIP
74079
Mailing
2100 WEST U.S. ROUTE 66 ATTN.: DAMIEN GONZALES, STROUD, OK 74079
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
333132
Employees
130
Ownership type
A

4 citations on file for this inspection.

1926.451 A01

Serious Gravity 5 1 instance 4 exposed
Issued
Penalty
Initial $5969.00 · Current $3100.00 Reduced
29 CFR  1926.451(a)(1):  Scaffold(s) and scaffold(s) component(s) were not capable of supporting, without failure, its own weight and at least four times the maximum intended load applied or transmitted to it:  On or about February 23, 2021, at the jobsite, the employer allowed employees to work from a shop made scaffold platform that was elevated by a powered industrial truck.  The scaffold platform extended more than ten (10) inches over the wheel base of the powered industrial truck and this exposed the employees to a fall hazard.
Recent events (2)
  • — I (S) $3100
  • — Z (S) $5969

1926.602 C01 II

Serious Gravity 5 1 instance 4 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR  1926.602(c)(1)(ii):  Modifications or additions which affect the capacity or safe operation of the equipment were made without the manufacturer's written approval:  On or about February 23, 2021, at the jobsite, the employer allowed employees to work from a shop made scaffold that was elevated by a powered industrial truck.  The employer did not obtain written approval from the manufacturer to use this powered industrial truck to elevate the scaffold with personnel and this exposed the employees to a fall hazard.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.501 B10

Serious Gravity 10 1 instance 4 exposed
Issued
Penalty
Initial $12288.00 · Current $6400.00 Reduced
29 CFR  1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system.     On or about February 23, 2021, at the jobsite, the employer required employees to perform roofing work activities from a roof of a commercial building.  The employees were not in use of fall protection and were exposed to a fall greater than six (6) feet to the ground below.
Recent events (2)
  • — I (S) $6400
  • — Z (S) $12288

1926.503 A01

Serious Gravity 5 1 instance 4 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR  1926.503(a)(1):  The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  On or about February 23, 2021, at the jobsite, the employer allowed employees to work from the roof of a building with unprotected sides and edges.  The employees were not trained to recognize the hazards of falling and the procedures to follow to minimize the hazards.  This exposed the employees to a fall hazard.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

View SERVICE KING MANUFACTURING, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345167027.