OSHA Inspection: BIGBEE STEEL BUILDINGS, INC.

Issued

2023-11-02 00:00:00

Abate by

2023-12-29 00:00:00

Penalty

Initial $9376.00 · Current $6094.00 Reduced

General-duty citation text

29 CFR  1910.132(d)(1): The employer did not assess the workplace to determine if hazards are present, or are likely to be present, which necessitate the use of personal protective equipment (PPE):   (a) Trim Panel department: On or about 5/5/2023, the employer exposed authorized employees to amputation hazards in that, adequate personal protective equipment  were not  selected and provided for the tasks such as but not limited to adjusting, cleaning and deburring the tooling wheels on machines, such as but not limited to, the Roll Former section of the ASC Machine, Model Select Series 1, Serial number JN 22191.00E.

Issued

2023-11-02 00:00:00

Abate by

2023-12-29 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1910.138(a):The employer did not select and require employee(s) to use appropriate hand protection when employees' hands were exposed to hazards such as those from skin absorption of harmful substances; severe cuts or lacerations; severe abrasion:  (a) Trim Panel department: On or about 5/5/2023, the employer exposed authorized employees to amputation hazards in that, employee were not provided adequate hand protection while performing task, such as but not limited to, adjusting, cleaning and deburring the tooling wheels on machines, such as but not limited to, the Roll Former section of the ASC Machine, Model Select Series 1, Serial number JN 22191.00E.

Issued

2023-11-02 00:00:00

Abate by

2024-02-29 00:00:00

Penalty

Initial $10938.00 · Current $7110.00 Reduced

General-duty citation text

29 CFR  1910.147(c)(1): The employer did not establish a program consisting of an energy control procedure, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative:  (a) Trim Panel Department: On or about 5/5/2023, the employer exposed authorized employees to amputation hazards in that, a program consisting of an energy control procedure, employee training and periodic inspections  was not developed and utilized.

Issued

2023-11-02 00:00:00

Abate by

2024-02-29 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section:   (a) Trim Panel Department: On or about 5/5/2023, the employer exposed authorized employees to amputation hazards in that, written lockout/tagout procedures were not developed and utilized for machines, such as but not limited to, the Roll Former section of the ASC Machine, Model Select Series 1, Serial number JN 22191.00E.