Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: BASTION TECHNOLOGIES, INC.

Federal Agency inspection · Safety discipline

On , OSHA opened a federal Agency safety inspection of BASTION TECHNOLOGIES, INC. in 6717 SOUTH FM 646, SANTA FE, TX 77510 (NAICS 541715). OSHA activity number 346860042.

Watch Bastion Technologies, INC. — free Get an email when a new federal OSHA severe-injury report for Bastion Technologies, INC. is published. One employer, no account, unsubscribe in one click.
Site address
6717 SOUTH FM 646
City
SANTA FE
State
TX
ZIP
77510
Mailing
17625 EL CAMINO REAL SUITE 330, HOUSTON, TX 77058
Inspection type
Federal Agency (M)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
541715
Employees
5
Ownership type
A

5 citations on file for this inspection.

5(a)(1)

Other-than-serious Gravity 10 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $16131.00 · Current $12099.00 Reduced
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to struck-by hazards from components of the accumulators:  a) On or about July 26, 2023, at the jobsite, employees were exposed to struck-by hazards.
Recent events (3)
  • — F (O) $12099
  • — C (S) $16131
  • — Z (S) $16131

1910.147 C01

Other-than-serious Gravity 10 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $16131.00 · Current $12099.00 Reduced
29 CFR  1910.147(c)(1):  The employer did not establish a program consisting of an energy control procedure, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative:  a)  On or about July 26, 2023 and at times prior thereto, at the facility, where the employer had not established an energy control program.  Employees perform servicing and maintenance activities on equipment such as, but not limited to, the Bastion Accumulator (SureShear) when testing, assembling, and disassembling the accumulators.
Recent events (3)
  • — F (O) $12099
  • — C (S) $16131
  • — Z (S) $16131

1910.147 C04 I

Other-than-serious Gravity 10 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $16131.00 · Current $0.00 Reduced
29 CFR  1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section:  a)  On or about July 26, 2023 and at times prior thereto, at the facility, where procedures had not been developed, documented and utilized for the control of potentially hazardous energy when employees performed servicing and maintenance activities such as, but not limited to, testing, assembling, and disassembling the accumulators on the Bastion Accumulator (SureShear).
Recent events (3)
  • — F (O) $0
  • — C (S) $16131
  • — Z (S) $16131

1910.178 L01 II

Other-than-serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $9218.00 · Current $6912.00 Reduced
29 CFR 1910.178(l)(1)(ii): The employer did not ensure that each operator had successfully completed the training required by paragraph (l), except as permitted by paragraph (l)(5), prior to permitting an employee to operate a powered industrial truck:  a) On or about July 26, 2023 and at times prior thereto, at the facility, employees were permitted to operate a forklift without completing the required training.
Recent events (3)
  • — F (O) $6912
  • — C (S) $9218
  • — Z (S) $9218

1910.178 L06

Other-than-serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.178(l)(6): The employer did not certify that each operator has been trained and evaluated as required by this paragraph (l):  a) On or about July 26, 2023 and at times prior thereto, at the facility, employees who operated forklifts were not certified to have been trained and evaluated on forklift operation.
Recent events (3)
  • — F (O) $0
  • — C (S) $0
  • — Z (S) $0

RNWBL

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346860042.