OSHA Inspection: FORTIS SOLUTIONS GROUP, LLC

Issued

2025-12-15 00:00:00

Penalty

Initial $6833.00 · Current $4783.00 Reduced

General-duty citation text

29 CFR  1910.303(b)(7)(iv):  There were damaged parts that adversely affected safe operation or mechanical strength of the equipment, such as parts that were broken, bent, cut, or deteriorated by corrosion, chemical action, or overheating:  Warehouse:  On, or about, August 5, 2025, the cover provided on Challenger dock plate control panel was broken and ajar.

Issued

2025-12-15 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1910.303(g)(1)(i)(C):  For electric equipment operating at 600 volts, nominal, or less to ground, and likely to require examination, adjustment, servicing, or maintenance while energized, the width of work space was not clear and did not extend from the grade, floor, or platform to the height required by paragraph (g)(1)(vi) of 29 CFR 1910.303.  Other equipment associated with the electrical installation and located above or below the electric equipment may extend not more than 153 mm (6 in.) beyond the front of the electric equipment:  Warehouse:  On, or about, August 5, 2025, a battery charging unit was installed in the working space of the Square D 120/208 volt Load Center.  The battery charging unit projected 13 inches beyond the face of the Load Center.

Issued

2025-12-15 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1910.303(g)(1)(ii):  The required working space about electric equipment rated 600 volts, nominal, or less to ground, was used for storage:  Warehouse:  On, or about, August 5, 2025, hand trucks and brooms were stored in the working space for the Square D Load Center.