Safety Incidents OSHA Severe Injury Reports · 2015–2025
2,004,209Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: BEST WELDING & FABRICATION INC

Unprogrammed Other inspection · Safety discipline

On , OSHA opened an unprogrammed Other safety inspection of BEST WELDING & FABRICATION INC in 3509 SOUTH ORANGE AVE, ORLANDO, FL 32806 (NAICS 332710). OSHA activity number 348479395.

Watch Best Welding & Fabrication INC — free Get an email when a new federal OSHA severe-injury report for Best Welding & Fabrication INC is published. One employer, no account, unsubscribe in one click.
Site address
3509 SOUTH ORANGE AVE
City
ORLANDO
State
FL
ZIP
32806
Mailing
31834 VINE STREET, SORRENTO, FL 32776
Inspection type
Unprogrammed Other (I)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Last modified
Data loaded
NAICS code
332710
Employees
3
Ownership type
A

5 citations on file for this inspection.

1926.501 B10

Serious Gravity 10 1 instance 3 exposed
Issued
Penalty
Initial $3972.00 · Current $2185.00 Reduced
29 CFR  1926.501(b)(10):Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system.  Or, on roofs 50-feet (15.25 m) or less in width, each employee was not protected by use of a monitoring system.  a) On or about  September 3, 2025,  at 3509 South Orange Ave Orlando Florida 32806 : Employees were exposed to an approximate 15  foot fall hazard while welding all thread pipes on a flat roof  in that, fall protection was not used.
Recent events (2)
  • — I (S) $2184.6
  • — Z (S) $3972

1926.701 B

Serious Gravity 10 1 instance 3 exposed
Issued
Penalty
Initial $3972.00 · Current $2185.00 Reduced
29 CFR  1926.701(b):All protruding reinforcing steel, onto and/or into which employees could fall, was not guarded to eliminate the hazard of impalement:  a) On or about  September 3, 2025,  at 3509 South Orange Ave Orlando Florida 32806 : Employees were exposed to  impalement hazards while working on the roof installing all thread steel rods, in that the steel rods were left uncapped.
Recent events (2)
  • — I (S) $2184.6
  • — Z (S) $3972

1926.1053 B22

Deleted Serious Gravity 10 1 instance 1 exposed
Issued
Penalty
Initial $3972.00 · Current $0.00 Reduced
29 CFR  1926.1053(b)(22):Employees  using ladders were carrying objects or loads that could cause the employee to lose balance and fall:  a) On or about September 3, 2025, at the jobsite, the employer exposed employees to a 15 foot, 5-inch fall hazard, in that, employees were allowed to carry materials and tools such as but limited to, 5-gallon bucket of caps to cover the All-Thread screws that were perturbing through the floor, on a Werner Aluminum Extension Ladder.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3972

1910.132 D02

Other-than-serious 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR  1910.132(d)(2):The employer did not verify, through a written certification, that the required workplace hazard assessment had been performed:  (a) On or about September 3 2025, at 3509 Orange Ave Orlando Fl: the employer did not provide a written certification as required by this section for required personal protective equipment including, but not limited to, Impalement hazards, ladder training, fall protection training , hardhats, when employees access the work site.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

1926.503 B01

Other-than-serious 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR  1926.503(b)(1):The employer did not verify compliance with paragraph (a) of this section by preparing a written (training) certification record including the name or other identity of the employee trained, the date(s) of the training, and the signature of the person who conducted the training or the signature of the employer.  a. On or about September 3 2025, at 3509 Orange Ave Orlando FL: the employer did not provide written fall protection training certificates for employees exposed to a fall hazard of 15 feet while installing all thread steel pipes.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

View BEST WELDING & FABRICATION INC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 348479395.