Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Yazoo Mills, Incorporated, 305 Commerece Street, NEW OXFORD, PENNSYLVANIA 17350
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
Employee was working on the PACO Re-Cutter Single Spin when the right index finger was amputated. EMS took the employee to York Hospital.
HospitalizedAmputationFinger(s), fingernail(s), n.e.c.Metal, woodworking, and special material machinery, unspecified
An employee had just spliced a new roll to the paper being fed into a winder machine. The employee realized the splice would not hold and was working to correct it when their right hand was caught between the winder head and a belt. The employee suffered broken fingers. The incident took place during a training activity.
An employee was using sandpaper to sand a mandrel on a re-cutter. The sandpaper snagged on the mandrel and pulled the employee's gloved right hand into the machine. The hand was amputated and the skin was torn off up to the elbow.
An employee was operating a re-cutter machine and turned it off to remove a piece of trim from the mandrel. The machine was not fully stopped before he began to remove the trim and the moving parts contacted his left hand, resulting in a partial left index finger amputation.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 322214)
An employee was using sandpaper to sand a mandrel on a re-cutter. The sandpaper snagged on the mandrel and pulled the employee's gloved right hand into the machine. The hand was amputated and the skin was torn off up to the elbow.
An employee was operating an industrial stapling machine and was wiping excess oil off of the tip of the machine when the machine stapled/lacerated a finger.
At approximately 1:00 a.m., on 7/15/2019, a machine operator was performing a maintenance procedure on a board press. The operator was connecting a wire when a cog (wheel) grabbed her right hand and damaged the tissue between the thumb and index finger and knuckles.
An employee was attempting to remove a metal lid that had been stamped and was stuck in a punch press die when the press was activated via the foot pedal, causing it to cycle and sever his left hand.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.