, OKLAHOMA—
Unit Drilling Company
Struck by swinging or slipping object, other than handheld, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury at Unit Drilling Company, Daisy 2411 1-27H, , OKLAHOMA on — Amputations, affecting the hand(s), n.e.c..
Final narrative
On 1/21/15 at about 16:20 pm a worker was hit by the tongs on his right arm, chest, and leg. He was transported to OU Medical Center where his right hand was amputated. Immediately before the accident the drilling line was stuck. The snub line connected to the tongs snapped causing the tongs to swing around and hit the worker.
More severe injuries at Unit Drilling Company
ANDREWS, TEXAS—
Unit Drilling Company
Employees were installing a blowout preventer. One employee's hand was caught between the actuator assembly cage and the top drive. His right index finger was crushed and later amputated.
VELMA, OKLAHOMA—
Unit Drilling Company
During drill rig set up, a raised piece of drill pipe slipped out of the pipe stop housing that keeps the pipe from moving when placed in the upright rack and an employee's left thumb was caught and crushed between the pipe and the housing. The employee was hospitalized for surgery.
MIDLAND, TEXAS—
Unit Drilling Company
A drilling rig was tripping pipe out of a hole. An employee grabbed the drill stand before the spinners latched, causing amputation of the employee's left middle finger.
MENTONE, TEXAS—
Unit Drilling Company
An employee was unlocking a saddle so it could latch around the pin that was holding it in place. When it was unlocked, it released down and caught and amputated the employee's left middle fingertip.
TARZAN, TEXAS—
Unit Drilling Company
An employee was moving a sub into a sub box when the sub structure crushed his right thumb.
View Unit Drilling Company's full OSHA safety record →
Similar incidents · Same event type
PORTAGE, WISCONSIN—
InterCon Construction, Inc.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
WYLIE, TEXAS—
RAVA Construction, LLC
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
MIDDLETOWN, OHIO—
Stein, LLC
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
SELMA, TEXAS—
7 Site & Utility, LLC
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
STERLING, ILLINOIS—
Sterling Steel Company, LLC
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 213111)
HANNIBAL, OHIO—
Hall Drilling, LLC
An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.
PILOT POINT, TEXAS—
C. Miller Drilling Inc
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
WATFORD CITY, NORTH DAKOTA—
Amercian Well Service Llp
An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.
WICKETT, TEXAS—
Axis Energy Services
An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.
PECOS, TEXAS—
ROBINSON DRILLING OF TEXAS, LTD
An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.
More severe injuries in OKLAHOMA
PRYOR, OKLAHOMA—
Rae Corporation
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
EL RENO, OKLAHOMA—
U.S. Department of Justice/Federal Bureau of Prisons/Federal Correctional Institution-El Reno
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
MCALESTER, OKLAHOMA—
Meeco Sullivan
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
BARTLESVILLE, OKLAHOMA—
Edward Jones Investments
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
GUTHRIE, OKLAHOMA—
Burgess Manufacturing of Oklahoma Inc.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.