Struck by object falling from vehicle or machinery-other than vehicle part · Crushing injuries
At a glance
Federal OSHA recorded a severe workplace injury
at 1st Employment Staffing, Gates Corporation, SILOAM SPRINGS, ARKANSAS 72761
on — Crushing injuries, affecting the ankle(s).
Final narrative
An employee was moving a mold with a crane in the research development pilot cell. While the mold was being transported, the end effectors holding the mold became disengaged, allowing the mold to fall approximately 3 to 4 feet to the floor. The mold struck and crushed both of an employee's ankles.
An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.
An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.
An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.
An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.
More severe injuries in this industry (NAICS 561320)
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
A temporary employee was rigging secondary steel when the steel joist fell to the ground and struck his lower left leg, resulting in fractures to the tibia and fibula.
A temporary employee was helping set up a stage for a concert. The employee was run over by a mobile cart and sustained a toe amputation. The employee was hospitalized.
The injured employee was operating a reach truck and stopped at an intersection within a warehouse. After a brief a conversation, another employee's reach truck accelerated unexpectedly and struck the injured employee's stationary truck crushing his foot. He sustained fractures to his left foot and toes requiring hospitalization and surgery.
A temporary employee was operating a plastic strapping machine on an assembly line. The machine wrapped the employee, causing crushing injuries to their ribs and a kidney. The employee was hospitalized.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.