Injured by slipping or swinging object held by other person · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Graphic Packaging International, Inc., 1000 JONESBORO ROAD, WEST MONROE, LOUISIANA 71294
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
Two employees were attempting to take the forks off of a forklift. One employee was using a pry bar to lift the forks and the other employee was using his hands to push the forks. The pry bar slipped from under the fork, causing it to pinch the fingers of the employee who had been pushing the forks. One of the employee's fingers was amputated to the first joint, while another finger had the very tip pinched off.
An employee was working with a pallet bagger, trimming excess corrugate off a tray. The load was raised on a lift table. The scrap being trimmed activated the lift table's photo eye, causing the table to lower. Its frame pinched the steel toe of the employee's left boot between a bracket and the concrete. The employee suffered fractures in the left foot and was hospitalized.
An employee was completing a quality check at the coating section of the paper machine. As the employee was clearing a coating buildup from the applicator roll, the employee's left hand was caught in a nip point between the applicator roll and coater roll and crushed.
While an employee was repairing a water condensate motor and pump, the grating covering an adjacent u-drain dislodged. This caused the employee's right leg to drop into hot water condensate resulting in a thermal burn to the lower right leg.
An employee was pushing a loaded pallet to the end of a conveyor at a press. The employee noticed a plastic pad lying in front of the pallet and was removing it when the pallet, still rolling, pinched the employee's right ring finger against the metal conveyor end stop amputating it.
On 10/10/2018, around 8:30 a.m., an employee was attempting to replace a motor on a press machine when the employee was pinned between the motor and the machine frame, suffering contusions that required hospitalization.
The injured employee was holding a board that was being cut by another employee. The board kicked back, causing the saw to amputate the employee's left little finger and lacerate their left hand, resulting in nerve damage.
On September 26, 2023, an employee was working in a trench box while a co-worker was lowering a piece of plastic pipe by hand using a rope. The pipe swung and struck the employee's hand, fracturing their right thumb and middle and ring fingers. The employee was hospitalized.
An employee went over to a co-worker's station while the co-worker was using a powered meat knife. As the injured employee was pointing, his right index fingertip was amputated.
Two employees were using a handheld banding tool to make banding tape for tent set-ups. One employee was holding the banding tool and the injured employee was looping a metal clip around the tape. The tool closed while the injured employee's hand was near the banding mechanism. The banding tape caught the employee's right ring finger as it tightened, resulting in a partial amputation.
An employee was holding a branch against a log on the ground to make a wedge while another employee was using a chainsaw to cut the wedge. The saw slipped and struck the employee holding the branch, resulting in a laceration to the right wrist.
More severe injuries in this industry (NAICS 322212)
An employee was resetting a slitter machine's counter when their left hand was crushed under two rotating score shafts. The employee sustained amputations to three fingers on their left hand.
An employee went to retrieve dunnage for a co-worker when his right hand became caught in the rollers on the box transfer conveyor. The employee sustained a partial amputation to his middle fingertip.
An employee was troubleshooting a mini-feeder. As the employee was tapping the rotating drive chain with an Allen wrench, the employee's right hand came into contact with the chain. The employee suffered partial amputations, lacerations, and fractures to the middle and ring fingers. The machine was unguarded at the time of the incident.
An employee was between two sections of a printer when they sustained amputations to three fingertips on their right hand from the running print rolls.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.