Graphic Packaging International, Inc.

An employee was working with a pallet bagger, trimming excess corrugate off a tray. The load was raised on a lift table. The scrap being trimmed activated the lift table's photo eye, causing the table to lower. Its frame pinched the steel toe of the employee's left boot between a bracket and the concrete. The employee suffered fractures in the left foot and was hospitalized.

An employee was completing a quality check at the coating section of the paper machine. As the employee was clearing a coating buildup from the applicator roll, the employee's left hand was caught in a nip point between the applicator roll and coater roll and crushed.

While an employee was repairing a water condensate motor and pump, the grating covering an adjacent u-drain dislodged. This caused the employee's right leg to drop into hot water condensate resulting in a thermal burn to the lower right leg.

On 10/10/2018, around 8:30 a.m., an employee was attempting to replace a motor on a press machine when the employee was pinned between the motor and the machine frame, suffering contusions that required hospitalization.

An employee was cleaning the roller on a printing press when the employee's right thumb was pulled into the in-going nip point, partially amputating the thumb tip. The press was unguarded at the time.

An employee was taking a trash cart to a dumpster when one of their fingers was pinched between the trash cart and the dumpster, resulting in a partial amputation.

An employee was pushing flat shopping carts back into the cart tunnel. When unjamming the carts, part of the cart struck the employee's left shin, resulting in a laceration and bleeding. The employee was hospitalized.

An employee was pulling a cart backward in a storage area when his right little finger was pinched between the cart frame and an electrical box mounted to the side of a support column. The employee's right little finger was partially amputated.

An employee was helping to push a welding trailer out of the path of a truck. The trailer then rolled over a half-inch elevation change that rocked the trailer toward an electrical box. The employee's finger was pinched between the welding trailer and electrical box, resulting in a finger amputation approximately 1/2-inch from the end.

An employee was unloading packages from a trailer onto a cart. While moving the cart, it struck the employee's heel causing a tear to their Achilles muscle. The employee required surgery.

An employee worked a shift and later experienced cramping in his arms and legs. He was hospitalized with dehydration.

An employee worked in the paper machine area for a shift, cutting corners off paper rolls around the roll machine. Afterwards, the employee sustained cramping and dehydration due to heat. The employee was hospitalized.

An employee was adjusting a trim sheet leading to a sheeter machine. Their glove became caught in the machine and the shearer closed on the employee's right hand, crushing it and breaking the hand and wrist.

An employee was troubleshooting a process upset. A nearby refiner had a pressure spike, causing the housing to separate slightly, which allowed the loss of primary containment. The employee was sprayed by hot water, resulting second- and third-degree burns on his torso and left arm.

On July 22, 2024, at 10:30 AM, an employee was responding to a pulp mill manufacturing process shutdown. Pulp stock overflowed through an engineered overflow pipe resulting in a buildup of stock in a bermed area. The stock was 140 to 150 degrees. The employee went to the bermed area to close an air-actuated process valve. While closing the valve, pulp stock entered the top of his boots and caused second-degree burns to both of his lower legs down to his feet. The employee was hospitalized.

A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.

A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.

A security employee was holstering her firearm when the gun discharged a bullet into her right leg. The employee was hospitalized.

A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.

An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.