Caught in or compressed by equipment or objects, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Eatmon Holdings, Inc., 201 N. County Road, KIMBALL, NEBRASKA 69145
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
Employee was changing out a hydraulic ram on a rig when a swivel on the come-along broke and pinched the employee's thumb. First aid was performed at the local hospital and then the employee was transported to Denver. An artery in the thumb was damaged and the right hand thumb was later amputated at the first joint.
AmputationFinger(s), fingernail(s), n.e.c.Oil drilling rigs and machinery
An employee was offloading containers from his truck using a deck that goes up and down. When the deck was up, he took a step and his foot went between the truck and the deck, resulting in a foot/ankle fracture.
An employee was using a hoist to lift large containers (420 pounds) of steel parts to be dipped into tanks. The employee set a container down on a support and his finger was caught between the container and the support, resulting in amputation just behind the first knuckle.
An employee was operating a riding mower. The employee's left hand became stuck between the mower's front left support bar and its reel. The employee suffered tendon damage to the middle three fingers.
An employee was guiding a motor into a container while a forklift was lowering it. The employee made contact with the motor, which amputated the top of his left thumb.
An employee was moving 4-inch square tubing from a pallet to a four-post rack when his right ring finger was caught between the end of a tube and the rack. The employee's finger was partially amputated.
More severe injuries in this industry (NAICS 213112)
An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.
An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.
An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.
An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.