Concrete Industries Nebraska City

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.

Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.

A metal tooling base was being moved by a forklift when the load shifted. An employee who was assisting went to stabilize the load and prevent it from sliding off the forks. The C-channel of the base crushed the employee's left hand against the concrete ground, resulting in the amputation of their third and fourth fingers.

An employee was patching precast concrete. He fell from a concrete wall support to the ground due to wind. He was hospitalized with fractures to his left ankle and right knee.

An employee was opening a precast concrete form and rolled his ankle. The employee required surgery on his ankle.

A driver slipped and fell to the ground while exiting his truck. He sustained a lacerated spleen.

An employee was cutting wood on a table saw when the wood got jammed. While clearing the jam, the wood moved forward and his left index and middle fingertips were amputated.

An employee was hammering a pin into an engine. When he struck the pin with the hammer, the pin shattered and a small piece entered the employee's leg. He was hospitalized and required surgery to remove the shard.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.

An employee was troubleshooting a thigh deboner on a poultry processing line. As he worked to dislodge a thigh bone caught in the blade mechanism, the machine amputated the first and second digits on his left hand. He was hospitalized.