NC Chocolate Manufacturing LLC.

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was going down a ramp to a basement to assist in cleanup efforts. The ramp had been closed to vehicle traffic all day, as it was slippery. The employee was halfway down the ramp when a forklift drove onto it, then slid down the ramp and struck him. The employee suffered a spinal fracture and was hospitalized.

An employee was clearing a jam and making an adjustment to a machine using the exit wheel. Their right thumb was caught in the machine and they sustained a partial amputation to the thumb tip.

An employee was pushing a bag that was stuck in the bag sealing machine when their right thumb became caught in one of the back wheels, resulting in an amputation of the thumb tip.

An employee was getting chocolate product from the outfeed of a wrapping machine when the rotating elevator that pushes wrapped chocolate onto the outfeed ramp caught her right middle fingertip, resulting in a partial fingertip amputation. The machine was guarded and in operation at the time of the incident.

An employee tripped over a mounted pipe and fell. The employee's chin struck the floor, and the employee suffered a broken jaw.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.