Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Heartland Scenic Studio, 5329 Lindbergh Dr., OMAHA, NEBRASKA 68110
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was ripping a board on a table saw when it kicked back. The saw blade amputated two fingers on his left hand.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
On August 13, 2025, an employee was feeding wire through a junction box to feed a 120-volt circuit near a 480-volt bus duct. The bus duct suddenly combusted, and the employee suffered burns to his left hand and upper body. He was hospitalized.
An employee was operating a brake press and making the final bend on a steel part. Her right middle finger got caught between the part and the top punch as it bent the part upward. The employee sustained a crush injury resulting in amputation of the fingertip.
An employee was feeding scrap metal into a chipper when his right hand was squeezed against a metal component of the machine. He suffered an amputation to the right index finger at the second joint.
On June 18, 2025, an employee working as a millwork installer was cutting shims using a circular saw. The saw hit a knot in the wood and jumped, cutting the palm of the employee's left hand and causing partial amputations to three fingers. The employee was hospitalized.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.