CENTRAL MOLONEY, INC.

An employee was stapling boxes when he lost his balance and the staple gun shot staples into his leg, resulting in a laceration to the right leg.

An employee was operating a pneumatic chop saw when his hand was struck by the blade, resulting in the amputation of all four left hand fingers at the lowest knuckle.

An employee was working on a production line when he began experiencing cramps in his legs and subsequently throughout his body. The employee was hospitalized due to heat stress.

An employee was hooking a welder gun into a feeding wire. The feeder caught the employee's right thumb, which was amputated. The employee was hospitalized.

An employee was clearing a jam on a shearing machine when the machine actuated via the foot pedal. The employee's left index finger was in the point of operation and was amputated between the first and second knuckle.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

An employee was troubleshooting a machine. He was investigating a slipping belt when it caught his left hand and pulled it into a pulley, partially amputating the tip of his thumb.

An employee was tilting a radiator in a fixture. The radiator moved in the fixture and crushed the employee's left index fingertip, causing an amputation.

An employee installed a busbar on a coil for a winding machine. The busbar hit a tension bar, causing his left ring finger to get caught between the coil and the tension bar, which pulled in the employee's glove and resulted in a medical fingertip amputation. The machine was guarded at the time.

An employee was operating a wire winding machine when their clothing was caught in a rotating component, pulling them into the equipment. The employee's right arm was fractured.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.