Other fall to lower level, unspecified · Traumatic injuries and disorders, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Kohler Company Inc, 300 South Oklahoma Street, SHERIDAN, ARKANSAS 72150
on — Traumatic injuries and disorders, unspecified, affecting the nonclassifiable.
Final narrative
A maintenance associate was on top of the scrubber unit on the mezzanine level. The guard rails had been removed to allow access for replacement units. The employee walked backwards off the mezzanine to the floor below.
An employee was on an A-frame ladder retrieving materials from a shelf. He slipped and fell and his leg got caught in the ladder rungs, breaking his left tibia.
An employee was unloading materials from a flatbed trailer when they fell from the trailer and landed on the ground. The employee sustained a fractured left leg.
An employee was unloading appliances at a customer location for delivery. The employee was moving a water heater to be placed on the liftgate when he stepped backward and fell to the ground. The employee sustained rib and back injuries.
An employee was on a ladder four feet above the ground to install insulation. The ladder began to slide and the employee jumped to the shop floor, breaking his left tibia and fibula at the ankle. He was hospitalized, requiring surgery.
An employee was replacing a rubber pad on the cylinder of a test station. Their right index finger was caught between a hydrant and a pneumatic cylinder of the test machine resulting in amputation of the fingertip.
An employee was driving a pallet jack. As they went to turn down an aisle, their foot was pinned against the pallet racking, resulting in a foot injury and laceration.
An employee was operating a hydraulic press, loading pre-cut tubes of copper into a feeder when the die closed on their right hand. The employee's right second, third, and forth fingers were amputated at the second knuckle.
An employee was conducting grinding operations on a cast iron pipe using a portable grinder. The grinder kicked back and struck the employee's right wrist and knee. The employee sustained a laceration to his right knee and a cut to his right wrist that injured an artery and a tendon.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.