LEXICON, INC

An employee was using a sleever bar to move a checker plate into place and secure it to the floor of a structure in the melt shop. The sleever bar became stuck and the employee used his left hand to lift the checker plate up enough to free the sleever bar. Once the bar was freed, the checker plate came down and pinched his left index finger between two pieces of plate. The employee suffered an amputation of soft tissue at the fingertip, which required hospitalization.

On May 16, 2025, an employee crossed over a stand to support a wide flange beam they were fabricating. The beam rolled over onto their lower right leg and foot, resulting in fractures.

An employee was placing a steel I-beam when it became stuck and would not settle onto the flanges. The employee was moving the beam and when it became unstuck and crushed the fingers on his left hand. The employee was hospitalized and required surgery.

The injured employee was assisting a crew to install a crane rail on an overhead crane girder. He was on the 40' x 10' grated surface between the crane rails positioning himself to receive the end of the crane rail. The crane rail was being pushed on rollers toward the employee's location and as he tried to pry the end of the crane rail up to get it on top of the next roller, he lost his balance and fell 36 feet to the ground below. The employee sustained fractures to their right ankle, pelvis, and left arm. The employee was wearing a personal fall arrest system, but was not tied off at the time.

An employee was installing drive shafts on an overhead crane. The drive shaft was rigged about 17 feet up with a wire rope choker. The drive shaft began slipping through the rigging, when it slid down and struck the injured employee's hard hat. He was knocked to his knees and landed on his right knee. The employee sustained an amputation to the right leg below the knee.

On 11/8/2023, at about 1:00 AM, an employee was engaged in an altercation with shoplifters. In the parking lot, the employee was struck by a vehicle driven by the shoplifters. The employee sustained injuries to both legs.

Two employees were engaged in a fight while the injured employee was working from a ladder. The co-worker pulled the ladder from underneath the injured employee, causing them to fall to the ground. The injured employee sustained a foot fracture and back injury.

A customer was driving their car out of the parking lot without paying their bill. The car struck an employee, who ended up on the hood of the vehicle. As the car turned onto the street, the employee was thrown off the hood and sustained a head injury requiring hospitalization.

An employee was working when a customer picked up a jump box and fled the store without paying. The employee was then struck by the customer's vehicle, resulting in ankle fractures.

An employee was walking through a hallway with two restrained residents when they were tripped by one of the residents, causing them to fall to the floor. The employee was hospitalized with a knee injury.

An employee was fixing a broken purlin at a worksite when they fell from the framing to the concrete floor approximately 19 feet below. The employee sustained brain bleeding and fractures to their face, vertebrae, and wrists.

Employees were removing scaffolding that was used to repair an ion exchange tank. The line was undergoing the regen process when a piece of scaffold struck a PVC pipe that transported hydrochloric acid (HCl). The injured employee was placing material inside a scaffold rack when he was sprayed in the face with HCl and sustained chemical burns to his eyes, face, chest, right arm, and left leg.

An employee was moving a ramming machine to a staging area. While using the controls on the side of the machine, there was a sudden heavy rainfall causing the equipment to slide. The ramming machine tipped over and caught the employee against the ground. The employee sustained a fracture to the right side of their pelvis and was hospitalized.

The injured employee was training a new employee on a dough machine. She went to show where the batter comes from and her right index fingertip was cut. The employee sustained an amputation to the fingertip. The machine was not guarded at the time of the incident.

An employee was operating a roller machine on a dirt slope when the machine hit a bump and fell onto it's side. While trying to get free of the falling machine, the employee's legs were pinned by the top bar of the cage. The employee was hospitalized and his left leg was amputated. He also sustained fractures to a hand and finger.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.