Eastern Wholesale Fence Co., Inc.

An employee was performing maintenance on a notching machine. The bottom piece of the machine caught the employee's right little finger, causing an open fracture to the finger. The employee was hospitalized and underwent surgery.

An employee was cutting PVC boards using a chop saw and amputated his left thumb and index finger.

An employee amputated her left middle fingertip.

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An employee was helping to install a tarp on a roof when they fell through a skylight to the ground below, resulting in fractures to their face and ribs.

On August 5, 2025, an employee was exiting a room when his left middle and ring fingers became caught in the door as it shut. The middle fingertip was amputated.

An employee was driving a forklift and unloading racks of glass from a truck. A rack began to tilt; the employee exited the forklift and went to stabilize it. The rack tipped and pinned his left arm against the forklift. The forearm was broken and required surgery.

An employee was sitting on a stack of steel beams. When they stood up, the top beam fell onto the employee, resulting in a broken left leg.

An employee was working to tow a forklift with another forklift when the tow line came loose and struck their face. The employee sustained head, face, and eye injuries.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.