Direct exposure to electricity, unspecified · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Marsh Bellofram Corporation, 8019 Ohio River Boulevard, NEWELL, WEST VIRGINIA 26050
on — Electrical burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
HospitalizedMultiple body parts, n.e.c.Presses, except printing, unspecified
More severe injuries at Marsh Bellofram Corporation
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
On December 5, 2023, an employee was changing out batteries in a battery cabinet. As he was routing a battery cable through a tray, the insulation boot came off the plug, which then touched the frame of the battery cabinet. This caused an arc flash that burned the knuckles of the fingers on the employee's left hand.
More severe injuries in this industry (NAICS 339991)
An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.
An employee was performing stamping operations using a 160-ton press machine. They began to clean the machine when the press came down on their hand, resulting in multiple finger amputations.
An employee was feeding a ring into a horizontal winder when the ring got caught. As the employee was getting it to continue feeding into the machine, her right middle finger was caught in a pinch point on the machine's wheel. The fingertip was partially amputated.
An employee was operating a tape cutting machine, which automatically cuts 2-inch cloth material into predetermined lengths. The material became jammed in the blade, which froze in the partway down position. The employee began working to unjam the material. The machine activated, causing the blade to become free. The blade came down and amputated the employee's left index fingertip above the first knuckle and the tip of their left thumb.
An employee was adjusting a ring on a bar bending machine when their glove became caught in a pinch point on the machine. The machine was activated and the employee sustained fractures to the four fingers on their right hand and amputations to the index and little fingers.
An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.
An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.
An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.