Pedestrian struck by vehicle backing up in nonroadway area · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Valk Manufacturing , 666 East Main Street, NEW KINGSTOWN, PENNSYLVANIA 17072
on — Soreness, pain, hurt-nonspecified injury, affecting the leg(s), unspecified.
Final narrative
An employee bending down to count snow blades was struck by a forklift being reversed by a coworker. The employee's leg got caught in the forklift's wheel well.
HospitalizedLeg(s), unspecifiedForklift, order picker, platform truck-powered
An employee was drilling bolt holes to fit the scrape blade on a snow plow. As the employee attempted to clear a metal shaving out from behind the bit, the employee's sleeve was caught and was pulled into the drill chuck, suffering a broken forearm. The drill chuck was guarded at the time.
An employee was looking into the bucket of a front-end loader to see how much material was in it. A skid steer backed into the employee, who then fell into the edge of the front loader's bucket and suffered internal bleeding in the abdominal area.
An employee was spotting for a forklift operation. The forklift backed over the employee, who suffered a complete amputation to one lower leg and a partial amputation to the other leg. The employee was hospitalized.
An employee was cleaning his work area and preparing it to begin making air-set molds
when a nearby forklift that was backing out from a load swung around and struck the employee. They sustained a lower left leg fracture.
An employee was working behind a stack of steel I-beams (stacked 2 columns deep and 4 levels high on the floor) while a forklift was pushing the stack. When the forklift took off the second-to-last beam, the last one was pushed over, causing it to fall to the ground and strike the employee. The employee sustained a fracture to the right leg.
An employee was lifting a flat sub (sheet steel) in the flats robot cell (weld area). He was operating a hoist when his left little fingertip got caught between the lifting device hook and the flat sub. The employee sustained a partial transphalangeal amputation.
An employee was underneath a 35-foot boom truck and adjusting the transmission linkage when the truck jumped over the wheel chocks and rolled over the employee's right leg, resulting in a fracture.
A crane was being used to lift a debris tank from a rack. The tank crushed the employee's right hand, causing amputations to the employee's right ring finger and little fingertip.
An employee was removing a small sheet metal part out of the die of the brake press. The foot pedal was pressed, causing the part to lift and crush their left thumb against the die. The employee suffered an amputation to the thumb tip including the loss of flesh and the fingernail.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.