Pedestrian struck by vehicle or object propelled by another vehicle in nonroadway area · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Riverside Industries LLC, 40361 200th Street, HURON, SOUTH DAKOTA 57350
on — Fractures , affecting the Leg(s) unspecified.
Final narrative
An employee was working behind a stack of steel I-beams (stacked 2 columns deep and 4 levels high on the floor) while a forklift was pushing the stack. When the forklift took off the second-to-last beam, the last one was pushed over, causing it to fall to the ground and strike the employee. The employee sustained a fracture to the right leg.
Hospitalized Leg(s) unspecified Forklift, order picker, platform truck powered
The injured employee was walking through the warehouse. Another associate was driving a forklift with a pallet of large format tile (slabs) when the slabs began to tip. The injured employee ran over to stop the slabs from falling, but the slabs fell on his lower left leg/foot. The employee sustained fractures in his lower leg and foot. He was hospitalized and required surgery.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was helping offload an aircraft. She was standing in the opening between a parked cart and an unoccupied aircraft tug when another vehicle struck a stationary bag cart, which then struck her. The employee suffered a skull fracture near the right eye, a right kneecap fracture, a nose fracture, and sinus damage, as well as soft tissue damage to the left calf and hip. She was hospitalized and required surgery.
An employee was cutting steel channels from a hanging rack that was being supported by a forklift. When they were finished, the forklift started moving the rack out of the area and a piece of material snagged one of the rack legs, causing the rack to tilt backward. The rack slipped off the forklift and struck the employee on his right side/lower back. He sustained a fractured pelvis and was hospitalized.
The injured employee was standing by one of the stationary computers along the wall. There was a half-pallet located approximately 3 feet behind the employee that consisted of 12-pound boxes stacked six boxes high. A forklift was transporting a pallet that came in contact with the stationary pallet behind the injured employee, causing four boxes to fall and contact their legs. The injured employee was hospitalized with leg injuries.
More severe injuries in this industry (NAICS 333120)
An employee was lifting a flat sub (sheet steel) in the flats robot cell (weld area). He was operating a hoist when his left little fingertip got caught between the lifting device hook and the flat sub. The employee sustained a partial transphalangeal amputation.
An employee was underneath a 35-foot boom truck and adjusting the transmission linkage when the truck jumped over the wheel chocks and rolled over the employee's right leg, resulting in a fracture.
A crane was being used to lift a debris tank from a rack. The tank crushed the employee's right hand, causing amputations to the employee's right ring finger and little fingertip.
An employee was removing a small sheet metal part out of the die of the brake press. The foot pedal was pressed, causing the part to lift and crush their left thumb against the die. The employee suffered an amputation to the thumb tip including the loss of flesh and the fingernail.
On November 12, 2024, an employee was performing repairs on an overhead door from a scissor lift. He was struck by a bridge crane and pinned between the scissor lift's railing and the crane's support structure. The employee was hospitalized with fractured ribs.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.