Nidec Motor Corporation

Employees were removing dies from a press. The injured employee was guiding a suspended die set by hand to ensure proper placement on the skid when the employee's gloved fingertips were pinched between the upper and lower dies of the blanket die set as it was lowered by a hoist onto a skid. The employee's left middle and ring fingertips were amputated.

An employee was loading large cylindrical arbors vertically into a cart with wheels when an arbor fell. This caused a shift in weight and the basket became top-heavy and tilted. The employee's hand was still on the lifting device connected to the hoist and arbor when the basket and arbors shifted. His left ring finger was caught in a pinch point, resulting in a fingertip amputation.

An employee was shimming a rotor assembly in a lathe to correct a run-out condition before turning the part in a CNC turning lathe. The tail stock foot pedal was actuated, closing the tail stock on and amputating her left index finger to the first knuckle.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was cleaning a machine and bleeding its lines. After the gauge read 0, the employee removed the metal lid covering a filter. The lid popped off and struck the employee in the face, causing a broken nose, a broken jaw, and lacerations.

An employee was burned by an arc flash that occurred in an electrical room.

An employee was carrying a metal plate (18 inches x 18.75 inches) when it dropped onto his right foot, resulting in a fracture.

An employee was troubleshooting a variable frequency drive (VFD). There was an electrical discharge. The employee experienced an electrical shock of approximately 480 volts and sustained second- and third-degree burns on their right hand, wrist, forearm, and elbow.

An employee was operating a press and sustained broken bones in the right hand.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.