Kerry Inc

On September 15, 2024, an employee was clearing a piece of paper on the heat sealer in the flour bagging area when they sustained a partial amputation of their left thumb at the first knuckle.

An employee was operating the bake sealer (used to seal the product) on the line and there a change over in the process. The employee was moving the bake sealer when he slipped and his hands were caught between the moving belts of it, resulting in a partial amputation of the left little finger.

An employee slipped on ice in a parking lot, fell, and suffered a fractured right femur.

An employee was operating the chunker when dough piled up underneath the chunker. The employee started to remove the dough when his hand got caught between the belt and the cutter on the chunker. The employee sustained an amputation to the right thumb.

Two employees were working to clear a jammed screw conveyor and replace a drive belt. The injured employee's left index finger was crushed in a nip point between the belt and pulley. Approximately one-third of the employee's finger was medically amputated.

An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.

An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.

An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.

An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.

An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.

An employee was going down a ramp to a basement to assist in cleanup efforts. The ramp had been closed to vehicle traffic all day, as it was slippery. The employee was halfway down the ramp when a forklift drove onto it, then slid down the ramp and struck him. The employee suffered a spinal fracture and was hospitalized.

An employee was clearing a jam and making an adjustment to a machine using the exit wheel. Their right thumb was caught in the machine and they sustained a partial amputation to the thumb tip.

An employee was pushing a bag that was stuck in the bag sealing machine when their right thumb became caught in one of the back wheels, resulting in an amputation of the thumb tip.

An employee was getting chocolate product from the outfeed of a wrapping machine when the rotating elevator that pushes wrapped chocolate onto the outfeed ramp caught her right middle fingertip, resulting in a partial fingertip amputation. The machine was guarded and in operation at the time of the incident.

An employee tripped over a mounted pipe and fell. The employee's chin struck the floor, and the employee suffered a broken jaw.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.