NEXTERA ENERGY POINT BEACH LLC

An employee was walking in a store when she tripped and fell to the floor. The employee sustained rib fractures.

An employee was walking through a hallway when they tripped and fell to the ground, resulting in a fractured left hip and femur.

An employee was walking on a concrete patio near the work site when he tripped and fell on his right side resulting in a fractured right femur.

An employee was loading a vehicle for mail delivery when she turned, tripped, and fell in the parking lot. The employee struck their head on the pavement and suffered a concussion.

The injured employee had been talking with another employee. As they went to turn around and walk, they tripped and fell to the floor. The employee was hospitalized with a broken hip.

An employee was using a chain fall to install a liner in a mill. As he was setting the liner in place, his right index finger got stuck in a chain on the rigging, resulting in a fingertip amputation that required hospitalization and a surgical reattachment.

An employee was descending a fixed 15-foot ladder. The employee slipped and fell, landing on a snubber machine 8 feet below and suffering a laceration to the left thigh and a fracture to the sternum.

An employee was walking to leave the worksite, slipped on mud, and fell to the ground. The employee suffered a C5 vertebra fracture that required surgery.

An employee was lowering himself on a scissor lift after inspecting a chain hoist. An auxiliary hoist being installed on the manipulator crane fell approximately 8 feet from its installed location and struck the employee in the upper back, fracturing two vertebrae.

An employee was assembling a pump with their left little finger positioned between the impeller and the discharge spacer. The element contacted the pump case's seating position and the shaft continued to move, pinching their fingertip between the two components. The employee sustained a fingertip amputation through part of the nail. The incident occurred during training.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.