Southwestern Power Administration

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was using a chain fall to install a liner in a mill. As he was setting the liner in place, his right index finger got stuck in a chain on the rigging, resulting in a fingertip amputation that required hospitalization and a surgical reattachment.

An employee was descending a fixed 15-foot ladder. The employee slipped and fell, landing on a snubber machine 8 feet below and suffering a laceration to the left thigh and a fracture to the sternum.

An employee was lowering himself on a scissor lift after inspecting a chain hoist. An auxiliary hoist being installed on the manipulator crane fell approximately 8 feet from its installed location and struck the employee in the upper back, fracturing two vertebrae.

An employee was assembling a pump with their left little finger positioned between the impeller and the discharge spacer. The element contacted the pump case's seating position and the shaft continued to move, pinching their fingertip between the two components. The employee sustained a fingertip amputation through part of the nail. The incident occurred during training.

An employee was walking down a gravel walkway. They went to turn, lost their footing, and fell. The employee sustained a right tibia/fibula and ankle fracture.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.