Exposure to electricity, unspecified · Electrocutions, electric shocks
At a glance
Federal OSHA recorded a severe workplace injury
at Vaughan & Bushnell Manufacturing Company, 201 W Main, BUSHNELL, ILLINOIS 61422
on — Electrocutions, electric shocks, affecting the bODY SYSTEMS.
Final narrative
On July 15, 2015, an employee was shocked while working on a press in the forge department and was hospitalized due to the injuries sustained.
On September 8, 2023, an employee was using an overhead hoist to dump a batch of center punches from a heat treating tub into the normalizer. The tub fell out of the dumping cradle and onto the employee's foot. The employee was hospitalized with multiple fractures to the left foot.
An employee was using a drill press to drill holes in a hammer handle. The rotating drill bit contacted the employee's right glove while the employee was clearing chips from the table. The employee suffered an amputation to the little finger at the first knuckle.
On September 17, 2018, an employee was testing a steel hammer handle in the gripper of an all-steel handle rougher when the employee's hand was caught between the steel hammer handle and a 50-grit belt, avulsing the employee's posterior right hand.
On September 4, 2018, at approximately 2:40 PM, an employee felt dizzy, passed out, hit his head, and suffered a head laceration. He was hospitalized for heat exhaustion.
An employee was on a ladder, working on lighting in a conference room ceiling. The employee was shocked and fell from the ladder to the floor. The employee lost consciousness and sustained burns.
An employee was riding on the side of a forklift. He stepped off the forklift and was struck by the back end of the forklift as it turned to the right. The forklift's back tire ran over his leg, resulting in an amputation. The employee was hospitalized.
An employee was loading a nozzle, weighing approximately 500 pounds, onto a positioner. The stainless steel nozzle slipped off the positioner and struck the employee's right leg. The employee's right tibia was fractured and their left knee was bruised.
An employee was preparing a hammer and dies for operation. The ram prop was inserted in the hammer to secure the ram. While the employee went to apply grease to the die shim in the hammer, the ram moved downward. The motion dislodged the prop, causing the ram to drop and crush the employee's right hand and forearm. The employee sustained amputations to their hand and arm and was hospitalized.
An employee was doing a tool changeover on a table mill and changing the mandrel. His hands were on both wrenches with his right thumb was between the two wrenches as he worked to unlock the mandrel. The wrenches came together, crushing his thumb. The employee was hospitalized with a partial amputation of the thumb.
An employee was helping to remove tooling that was stuck in a forging press (a full-revolution mechanical power press). The press cycled, resulting in partial amputations to two fingers on his left hand.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.