Hackney Ladish

An employee was operating an industrial band saw that is equipped with a hydraulic pipe clamp when his hand was caught between the clamp and the pipe he was cutting. His two left middle fingers were amputated. The band saw was unguarded at the time.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was rolling a pipe in a cutting rack and his right little finger became caught between sections of the pipe. The employee's finger was surgically amputated.

An employee was working a vertical bandsaw, cutting half-inch diameter rods into pieces. While using a steel chisel to move the cut pieces, the blade caught his leather glove and pulled his index finger in. The employee sustained an amputation of the finger between the first and second knuckle.

An employee was operating a lathe in a machine shop. The rotating head of the lathe caught the employee's left glove, resulting in a compound open fracture to the left wrist and a laceration to left ear.

An employee was descending the stairs of an oil/gas rig. As he approached the fifth step from the bottom, he slipped. His left ankle was caught in the steps, and he suffered fractures to the left fibula, tibia, and talus. He was hospitalized, requiring surgery.

The injured employee was loading a piece of pipe into a pipe bending machine. He had his right hand on the front of the loader while his left hand supported the piece of pipe in the back. A second operator had slightly clamped around the pipe to keep it in place. The third operator called out a measurement. The machine actuated and caught the the injured employee's left middle and ring fingers between the wiper and the material. The employee required surgery and sustained amputations to the distal joint of the middle and ring fingers.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.