Safety Incidents OSHA Severe Injury Reports · 2015–2025
105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31

Precision Drilling

Struck by falling object or equipment, unspecified · Fractures

Federal OSHA recorded a severe workplace injury at Precision Drilling, Rig 559, ORLA, TEXAS 79770 on — Fractures, affecting the chest, except internal location of diseases or disorders.

Watch Precision Drilling — free Get an email when a new federal OSHA severe-injury report for Precision Drilling is published. One employer, no account, unsubscribe in one click.

On or about 19 July 2015, at approximately 1600 hours, an employee of Precision Drilling was lowering a roof over the mud tanks area during rigging down procedures. The roof fell on top of him, fracturing his ribs. He was hospitalized.

Hospitalized Chest, except internal location of diseases or disorders Caps, lids, covers, n.e.c.

Precision Drilling

An employee was assisting in pulling a dryer shaker into position when the tow chain broke and a link from the chain struck the back of his head and knocked him unconscious. The employee sustained a concussion.

Precision Drilling

An employee was clearing ice on top of a drilling rig doghouse landing. Hinges broke when the employee jumped to clear the ice, and the employee fell to the ground 20-plus feet below. The employee suffered fractures to the lumbar region, wrist, and ankle.

Precision Drilling

On September 24, 2020, at approximately 11:00 a.m. an employee was walking from an area to the next well. A guide bar for the rear drilling area was lodged on a matting board. As the employee attempted to dislodge the guide bar, he was struck by the bar resulting in a fractured lower right leg.

Precision Drilling

The employee was assisting with mobile rig removal from a well site. As pipe was being pulled from the hole, rope used for pullout got caught up and pipe began to slip. The employee reached in to grab the pipe and his hand/finger was caught between piping and the drilling equipment, resulting in amputation of the right middle finger down to the knuckle.

Precision Drilling

During rigging down of a drilling rig, two employees attempted to lift/move an I-beam by hand. The I-beam shifted and crushed one of the employee's right middle finger resulting in amputation of the fingertip/print pad.

View Precision Drilling's full OSHA safety record →

Amazon FTW5

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

Tuff Shed, Inc.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

Lufkin Industries

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

Cy-Fair Coatings Inc

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

Rodriguez General Carpentry

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

Hall Drilling, LLC

An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.

C. Miller Drilling Inc

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

Amercian Well Service Llp

An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.

Axis Energy Services

An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.

ROBINSON DRILLING OF TEXAS, LTD

An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.

T G Meat Center LLC

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

Professional Flooring Supply

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

EnviroSafe Demil LLC

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

Inteplast Group

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

Regency IHS of Fairwinds Halletsville, LLC

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.