JORDAN HIGH VOLTAGE INC

An employee was working on a 7.6 kV electrical switch gear panel to add a new cable. The employee was electrocuted and sustained burns to both feet and the right hand.

On 8/13/2015, at approximately 10:00 a.m., an employee was installing electrical insulation on powerlines when a pin broke as he was coming down inside the bucket of a boom truck. He fell and hit the ground while still inside the bucket, breaking his ribs and injuring his right ankle.

An employee was stepping down from the tailgate of a customer's pickup truck. The truck then backed up and struck the employee, then pulled forward, striking them again while they were underneath the truck. The employee sustained fractures to their L3 vertebra, ribs, and a leg.

An employee was in front of a skid loader that was hauling a tree to be planted. The employee was holding the tree so it wouldn't fall over when his leg and foot were run over by the skid loader and fractured.

An employee was walking through the parking lot, returning from their break, when a motor vehicle struck them. The employee sustained a concussion, facial fracture, and contusions.

An employee was walking up to a powered industrial vehicle (PIV) to grab a water bottle. As the vehicle was turning, the employee was struck by the PIV and sustained a spleen laceration and injury to the left arm and chest. The employee was hospitalized.

While standing on the curb in front of the store, an employee was struck by a car. The car was then put in reverse and ran over the employee again. The employee sustained fractures to their ribs and both legs.

An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.

An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.

The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.