Pyramid Mountain Lumber Inc.

An employee fell while greasing an idler wheel, injuring his lower back.

An employee received a partial right thumb amputation while strapping lumber on the dry chain.

An employee was transitioning from a ladder onto a roof when the ladder slipped and they fell approximately 20 feet to the ground. The employee was hospitalized with fractures to their pelvis and heel.

An employee was tearing down shingles when they fell approximately 18 feet from a roof to the ground, sustaining a broken ankle.

An employee was climbing a ladder to bring material onto a roof. The ladder slid and the employee fell 16 feet to the ground, resulting in a broken knee.

An employee was performing an inspection of a bridge crane while working from a 19-foot scissor lift. The employee was going to use a pendant to move the crane to access a different portion of the crane for visual inspection. The scissor lift guard rails were below the girder of the crane to avoid contact. The tow arm for the crane collectors contacted the guardrail of the scissor lift and caused it to tip over. The employee stayed inside the scissor lift basket as he fell to the floor. The employee sustained fractures to the right arm and hip.

An employee was on a forklift that was elevated approximately 20 feet and was auditing inventory. The forklift malfunctioned and the employee fell down to the surface below, causing them to sustain multiple fractures.

An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.

An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.

An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.

An employee was working to get a log back onto a carriage. The employee came into contact with the running saw, which amputated their arm.

While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.

An employee was fixing an issue with seed cleaning equipment when he slipped on the ladder he was on. He went to catch himself and his hand went into a moving belt and pulley on the cleaner. The employee sustained the amputation of his right middle and index fingertips just below the fingernails.

An employee was riding an all-terrain vehicle (ATV) to move a bison herd. He was riding up the side of a steep hill when the ATV struck a rock and rolled, ejecting the employee before rolling over him. The employee suffered broken vertebrae in his back that required hospitalization.

An employee was clearing out dirt from an underground pipe when he was bitten by a rattlesnake on his hand.

An employee was climbing in the spreader area to remove a pasta jam when his right little finger was cut by the rotary cut-off knife. The employee sustained a laceration and fracture, resulting in an amputation.

A smoke jumper parachuted out of a helicopter during a forest fire response, landed on steep rugged terrain, and suffered femur and rib fractures and a liver laceration. The employee was hospitalized.