Homasote Company

An employee was clearing a jam from a conveyor table. A chain and sprocket in the machine caused the amputation of the employee's left middle fingertip.

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee worked a shift and later experienced cramping in his arms and legs. He was hospitalized with dehydration.

An employee worked in the paper machine area for a shift, cutting corners off paper rolls around the roll machine. Afterwards, the employee sustained cramping and dehydration due to heat. The employee was hospitalized.

An employee was adjusting a trim sheet leading to a sheeter machine. Their glove became caught in the machine and the shearer closed on the employee's right hand, crushing it and breaking the hand and wrist.

An employee was troubleshooting a process upset. A nearby refiner had a pressure spike, causing the housing to separate slightly, which allowed the loss of primary containment. The employee was sprayed by hot water, resulting second- and third-degree burns on his torso and left arm.

On July 22, 2024, at 10:30 AM, an employee was responding to a pulp mill manufacturing process shutdown. Pulp stock overflowed through an engineered overflow pipe resulting in a buildup of stock in a bermed area. The stock was 140 to 150 degrees. The employee went to the bermed area to close an air-actuated process valve. While closing the valve, pulp stock entered the top of his boots and caused second-degree burns to both of his lower legs down to his feet. The employee was hospitalized.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.