Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Briggs Equipment, 947 Industrial Park Drive , CLINTON, MISSISSIPPI 39056
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
On September 3, 2015, at 3:30 p.m., an employee's left pinky finger got caught in the lift chain of a forklift. The bottom third of his pinky finger was amputated, requiring overnight hospitalization.
HospitalizedAmputationFinger(s), fingernail(s), n.e.c.Forklift, order picker, platform truck-powered
An employee was performing maintenance on a backhoe, removing a hydraulic hose. The right valve released hydraulic fluid under pressure. His hand was scraped, and an amount of hydraulic fluid got under his skin.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333924)
An employee was using a punch and hammer to remove a pin from the mast of a forklift. The mast was secured by an overhead crane. The mast shifted, and the employee's thumb was pinched between the mast and the punch, resulting in an amputation to the tip of his left thumb.
On September 22, 2025, an employee tripped and fell over a permanent fixture (angle iron) that serves as a parking block in the back of a facility. He suffered a fractured right hip and was hospitalized.
An employee was helping a customer with repairs on their trailer. While lowering the ramp door of the trailer, the customer dropped the door and it contacted the employee's left ring finger, resulting in a fingertip amputation.
An employee was working to lay a part in the vise of the band saw in preparation for cutting. The left vise closed, pinching his fingertips against the part. The employee's middle and ring fingertips were amputated and they sustained a laceration to the index finger requiring stitches.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.