105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

INTERSTATE STEEL BUILDERS, INC.

Struck against stationary object or equipment while rising · Bruises, contusions

Federal OSHA recorded a severe workplace injury at INTERSTATE STEEL BUILDERS, INC., Hanger 5, SAN DIEGO, CALIFORNIA 92102 on — Bruises, contusions, affecting the abdomen, except internal location of diseases or disorders.

An employee was operating a manlift and struck their abdomen against the roof joist causing a contusion.

Hospitalized Abdomen, except internal location of diseases or disorders Roof trusses, joists

Cooperative Laundry

An employee bent over to pick up sheets off the floor. As she as standing back up, her head struck a clamp on a piece of machinery, resulting in a skull fracture.

Rent The Runway Inc.

An employee was climbing a portable ladder to retrieve an item from the second level when she hit her head against a ceiling reinforcement. The employee sustained a concussion and lacerations.

TranSource Truck & Equipment

An employee was underneath a construction loader truck while working on it. As the employee got up, they struck their head on the frame of the truck and were hospitalized overnight for a concussion.

Mission Foods

An employee was squatting to inspect a dough mixer. She struck her head and lost her balance, causing her to grab onto a piece of machinery. The machine crushed her right index finger, resulting in an amputation.

Union Paving & Construction Co., Inc.

An employee was setting a pipe in a trench about 3 feet deep. When he stood up, his head hit the wall of the trench and he suffered a neck injury.

Foundation Steel, LLC

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

Red Dot Corporation

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

Cornell & Company, Inc.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

K Constructor, LLC

An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.

Bowman Steel, LLC

An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.

Department of Justice - USMS

The injured employee was assisting a Department of Homeland Security (DHS) enforcement operation. During an apprehension, officers returned fire at a subject and struck the employee with a bullet. The employee sustained a gunshot wound to their right hand.

M1 Support Services

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

Dept. of Defense - USN

An employee was working on an electrical panel in a mechanical room when an arc flash occurred. The employee suffered burns.

Dept. of Homeland Security - CBP

At about 3:10 p.m. on October 3, 2025, an employee was inspecting a car. Two dogs that had been in another car were leashed and tethered to a bollard. As the employee inspected the first car along with a narcotics detection dog, one of the other dogs came loose and attacked the narcotics dog. The employee was separating the dogs when the other dog bit his left ring finger. The last joint of the finger was injured and part of it was bitten off.

Sycuan Casino Resort

An employee was preparing a bundle of green onions for chopping. While holding the bundle in his left hand, he made his first cut using a 9-inch kitchen knife held in his right hand. The knife contacted the tip of his left thumb, resulting in an amputation of approximately 0.5 inches of the thumb that required hospitalization.