Briggs & Stratton Corporation

An employee was working on a belt-driven coolant pump when his left hand was caught in the belt, resulting in lacerations and fractures. He was hospitalized and required surgery.

An employee was changing a water hose on a die machine. The employee had extended the ram of the machine fully to gain access to the water line. As the employee was checking the water hose, the hydraulics on the ram released, causing the ram to retract to its holding position. The ram caught the employee's hands, pinned them, and broke bones in both hands.

An employee was on a fiberglass step ladder, about 3 feet off the ground, capping off a dead air line. The employee fell off the ladder and suffered two broken ribs, a punctured lung, and head trauma.

An employee was asked to help perform maintenance on a die cast machine. The employee entered the work area, got into a kneeling position, and began using an open-end wrench to remove a hydraulic hose so a fitting could be repaired. When the hose came free from the fixture, residual hydraulic pressure released and hydraulic fluid struck the employee in the chest. The employee fell backward and struck his head on surrounding machinery. The employee was hospitalized with a subdural hematoma, fractures to the forehead, orbital area, and ribs, and required stitches for a forehead laceration.

A trim die was being transported by a forklift. When the die was placed on the ground, the top part of it popped off and crushed an employee's hand against a set of metal stairs. The employee suffered a laceration to the right hand between the thumb and the index finger.

An employee was going to the breakroom when they tripped over a chair and fell, resulting in a hip fracture.

An employee arrived at work and was walking into the store through the parking lot. The employee tripped over a curb and fell to the ground, sustaining a femur fracture.

An employee tripped over a box and fell to the floor, fracturing their right arm.

An employee tripped over a piece of angle iron and fell to the floor sustaining a broken hip.

An employee was preparing for a CT scan when she tripped over a loose strap and fell to the floor, fracturing her hip.

An employee was cleaning a machine and bleeding its lines. After the gauge read 0, the employee removed the metal lid covering a filter. The lid popped off and struck the employee in the face, causing a broken nose, a broken jaw, and lacerations.

An employee was burned by an arc flash that occurred in an electrical room.

An employee was carrying a metal plate (18 inches x 18.75 inches) when it dropped onto his right foot, resulting in a fracture.

An employee was troubleshooting a variable frequency drive (VFD). There was an electrical discharge. The employee experienced an electrical shock of approximately 480 volts and sustained second- and third-degree burns on their right hand, wrist, forearm, and elbow.

An employee was operating a press and sustained broken bones in the right hand.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.