Georgia Pacific

On June 16, 2023, at 7:45 AM, an employee was operating a plate forming press and went to remove a piece of tape from inside the machine. The machine cycled and amputated their left ring fingertip.

On 7/17/2021, at approximately 6:30 p.m., a temporary employee was operating a battery powered pallet jack. While walking backward, he tripped over the forks of a parked forklift. The pallet jack continued moving, rolling up onto his right leg and fracturing the ankle and foot. The employee was hospitalized.

A maintenance employee was servicing a piston cylinder when the rod and rod head came loose from the framework holding it. He and another maintenance employee were lifting the cylinder with a hoist and the cylinder head fell approximately 20-24" and struck the employee's left ring finger, causing a fracture and a partial degloving. The employee was hospitalized and required surgery.

A coater operator was working at a board machine, adjusting the coater wipe at the coater rolls. The rolls caught the employee's right forearm, crushing it. He was hospitalized and his right hand was surgically amputated.

While stepping off a deck that was 2 inches above the floor, an employee suffered a twisted right ankle and fractures to the tibia and fibula.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

Tools and parts were being lowered to the ground from an elevated platform in a 5-gallon bucket. The rope being used to lower the bucket failed; the tools and parts fell and lacerated the left forearm and upper left leg of an employee on the ground.

An employee was tracking an infeed belt on a scrap hogger when their right arm was caught between the belt and a roller. The arm was broken and the employee's shoulder was dislocated. The employee was hospitalized.

An employee was working to clear a jam from a paper napkin folder. The ram that advanced the napkins pushed the employee's right arm into the side of the machine, causing several lacerations and a hairline fracture.

An employee was troubleshooting overflowing ink on a printer-slotter machine when their right ring fingertip was caught in a guarded roller, resulting in a partial amputation.

An employee was disconnecting wires in preparation to swap out a refiner motor when they contacted energized equipment and sustained an electrical shock. The employee was hospitalized.

A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.

A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.

A security employee was holstering her firearm when the gun discharged a bullet into her right leg. The employee was hospitalized.

A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.

An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.