Direct exposure to electricity unspecified · Electrocution, electric shock
At a glance
Federal OSHA recorded a severe workplace injury
at Domtar, 1000 Papermill Road, GRENADA, MISSISSIPPI 38901
on — Electrocution, electric shock, affecting the BODY SYSTEMS .
Final narrative
An employee was disconnecting wires in preparation to swap out a refiner motor when they contacted energized equipment and sustained an electrical shock. The employee was hospitalized.
Hospitalized BODY SYSTEMS Washing, refining, and pulping machinery paper production
An employee was working to start an aerator machine on the front lawn of the customer's property. They pulled the starter cord of the machine and sustained an electrical shock to their right arm/hand.
An employee was adjusting the height of an ultraviolet (UV) lamp. She was electrocuted by the UV machine. She sustained burns on her left hand and an entry wound on the right forearm. The employee was hospitalized.
Tools and parts were being lowered to the ground from an elevated platform in a 5-gallon bucket. The rope being used to lower the bucket failed; the tools and parts fell and lacerated the left forearm and upper left leg of an employee on the ground.
An employee was tracking an infeed belt on a scrap hogger when their right arm was caught between the belt and a roller. The arm was broken and the employee's shoulder was dislocated. The employee was hospitalized.
An employee was working to clear a jam from a paper napkin folder. The ram that advanced the napkins pushed the employee's right arm into the side of the machine, causing several lacerations and a hairline fracture.
An employee was troubleshooting overflowing ink on a printer-slotter machine when their right ring fingertip was caught in a guarded roller, resulting in a partial amputation.
An employee was removing the prime port on the seal water recovery pump when water flashed over (became steam) and blew out of the port. The employee sustained first- and second-degree burns to their face, torso, chest, both arms, and upper right thigh.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.